Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 229
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command configures the G.8032 ring protection link type as owner or neighbor. The no form of the
command means this node is not connected to an RPL link. When RPL owner or neighbor is specified either
the a or b path must be configured with the RPL end command. An owner is responsible for operation of the
rpl link. Configuring the RPL as neighbor is optional (can be left as no rpl-node) but if the command is used
the nbr is mandatory.
The no form of this command removes the RPL link.
Default no rpl-node
node-id
Syntax node-id
no node-id
Context config>eth-ring
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This optional command configures the MAC address of the RPL control. The default is to use the chassis
MAC for the ring control. This command allows the chassis MAC to be overridden with another MAC
address.
The no form of this command removes the RPL link.
Default no node-id
Parameters mac — <xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx>
sub-ring
Syntax sub-ring {virtual-link | non-virtual-link}
[no] sub-ring
Context config>eth-ring>sub-ring
Description- Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command specifies this ring-id to be sub-ring as defined in G.8032. By declaring the ring as a sub-ring
object, the ring will only have one valid path and the sub-ring will be connected to a major ring or a VPLS
instance. The virtual-link parameter declares that a sub-ring is connected to another ring and that control
messages can be sent over the attached ring to the other side of the sub-ring. The non-virtual channel
parameter declares that a sub-ring may be connected to a another ring or to a VPLS instance but that no
control messages from the sub-ring use the attached ring or VPLS instance. The non-virtual channel
behavior is standard G.8032 capability.
The no form of this command deletes the sub-ring and its virtual channel associations.
To Next Page
Loading...
Need help?
General
