Nokia 7210 SAS-M Configuration Guide

Ethernet Ring Commands
Page 228 7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide
down
Syntax down down-timeout
Context config>eth-ring>ccm-hold-time
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command specifies the timer, which controls the delay between detecting that ring path is down and
reporting it to the G.8032 protection module. If a non-zero value is configured, the CPM will wait for the
time specified in the value parameter before reporting it to the G.8032 protection module.
Note: This parameter applies only to ring path CCM. It does NOT apply to the ring port link state. To damp
ring port link state transitions, use hold-time parameter from the physical member port.
Default 0 - the fault will be reported immediately to the protection module.
Parameters value — Specifies the down timeout.
Values 0 — 5000 deciseconds
up
Syntax up up-timeout
Context config>eth-ring>ccm-hold-time
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command specifies the timer, which controls the delay between detecting that ring path is up and
reporting it to the G.8032 protection module. If a non-zero value is configured, the CPM will wait for the
time specified in the value parameter before reporting it to the G.8032 protection module.
Note: This parameter applies only to ring path CCM. It does NOT apply to the member port link state. To
damp member port link state transitions, use hold-time parameter from the physical member port.
Default 20 deciseconds
Parameters value — Specifies the hold-time for reporting the recovery.
Values 0 — 5000 deciseconds
rpl-node
Syntax rpl-node <owner | nbr>
no rpl-node
Context config>eth-ring

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English