Nokia 7210 SAS-M Configuration Guide

Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 227
This command configures the guard time for an Eth-Ring. The guard timer is standard and is configurable
from “x”ms to 2 seconds
The no form of this command restores the default guard-time.
Default 5 deciseconds
Parameters value — Specifies the guard-time.
Values 1—20 deciseconds
revert-time
Syntax revert-time time
no revert-time
Context config>eth-ring
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command configures the revert time for an Eth-Ring. It ranges from 60 seconds to 720 second by 1
second intervals.
The no form of this command this command means non-revertive mode and revert time essentially is 0
meaning the revert timers are not set.
Default 300 seconds
Parameters value — Specifies the guard-time.
Values 60 —720 seconds
ccm-hold-time
Syntax ccm-hold-time {down down-timeout | up up-timeout}
no ccm-hold-time
Context config>eth-ring
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command configures eth-ring dampening timers.
The no form of this command set the up and down timer to the default values.

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English