Port Show Commands
Page 284 7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide
Sample Output
*A:ALU-211# show port 1/1/2
===============================================================================
Ethernet Interface
===============================================================================
Description : 10/100 Ethernet TX
Interface : 1/1/2 Oper Speed : 100 mbps
Link-level : Ethernet Config Speed : 100 mbps
Admin State : up Oper Duplex : full
Oper State : up - Active in LAG 10 Config Duplex : full
Physical Link : Yes MTU : 1514
Single Fiber Mode : No : Internal
IfIndex : 35717120 Hold time up : 0 seconds
Last State Change : 12/16/2008 19:31:40 Hold time down : 0 seconds
Last Cleared Time : 12/16/2008 19:31:48
IP MTU : 1000
===============================================================================
*A:ALU-211#
*A:ALU-211# show port 1/1/2
===============================================================================
Ethernet Interface
===============================================================================
Description : 10/100 Ethernet TX
Interface : 1/1/2 Oper Speed : 100 mbps
Link-level : Ethernet Config Speed : 100 mbps
Admin State : up Oper Duplex : full
Oper State : down - Standby in LAG 10 Config Duplex : full
Physical Link : Yes MTU : 1514
Single Fiber Mode : No : None
IfIndex : 35717120 Hold time up : 0 seconds
Last State Change : 12/16/2008 18:28:52 Hold time down : 0 seconds
Last Cleared Time : 12/16/2008 18:28:51
IP MTU : 1000
===============================================================================
*A:ALU-211#
*A:7210SAS>show# port
==============================================================================
SFP/MDI MDX
GIGE — Indicates the GigE SFP type.
FASTE — Indicates the FastE SFP type.
MDI — Indicates that the Ethernet interface is of type MDI (Media
Dependent Interface).
MDX — Indicates that the Ethernet interface is of type MDX (Media
Dependent Interface with crossovers).
IP MTU
Displays the configured IP MTU value.
Label Description (Continued)