Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 59
VPLS Service:
SDP to SDP
IP traffic (Learnt): Source and
Destination MAC (Outer MACs
inside the payload, just after the
MPLS header)
IP traffic (Unlearnt): Hash-2 and
parameter under hash-2 used.
PBB traffic (Learnt): Source and
Destination MAC (Outer MACs
inside the payload, just after the
MPLS header), ISID
PBB traffic (Unlearnt): Hash-2 and
parameter under hash-2 used.
Non-IP traffic (Learnt): Source and
Destination MAC (Outer MACs
inside the payload, just after the
MPLS header), EtherType
Non-IP traffic (Unlearnt): Hash-2
and parameter under hash-2 used.
IP traffic (Learnt and Unlearnt):
Source and Destination MAC
(Outer MACs inside the payload,
just after the MPLS header),
Ingress Port-Id
PBB traffic (Learnt and Unlearnt):
Source and Destination MAC
(Outer MACs inside the payload,
just after the MPLS header), ISID,
Ingress Port-Id
Non-IP traffic (Learnt and
Unlearnt): Source and Destination
MAC (Outer MACs inside the
payload, just after the MPLS
header), EtherType, Ingress Port-
Id
MPLS – LSR All traffic: Source and Destination
MAC (Outer MACs of the ethernet
packet that encapsulates MPLS
packet)
All traffic: MPLS label stack (Two
labels deep), Ingress Port-Id.
LAG Hashing Fields used for 7210 SAS-M (Network
mode)
Table 8: LAG Hashing mechanism for services configured in Network Mode on 7210
SAS-M devices (Continued)
Traffic direction
(For example SAP
to SDP)
Packet fields used for Hashing
for different traffic types with
hash-1
Packet fields used for Hashing
for different traffic types with
hash-2