Nokia 7210 SAS-M Configuration Guide

LAG Hashing Fields used for 7210 SAS-T Network Mode
Page 72 7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide
Epipe service:
SDP to SAP
IP traffic: Source and Destination MAC
(Outer MACs inside the payload, just
after the MPLS header), Source and
Destination L4 ports, VLAN
PBB traffic: Source and Destination
MAC (Outer MACs inside the payload,
just after the MPLS header).
Non-IP traffic: Source and Destination
MAC (Outer MACs inside the payload,
just after the MPLS header), EtherType.
All traffic: Source and Destination MAC
(Outer MACs inside the payload, just
after the MPLS header), Ingress Port-Id.
VPLS service:
SDP to SDP
All traffic (Learnt): Source and
Destination MAC (Outer MACs inside
the payload, just after the MPLS header)
All traffic (Unlearnt): Hash-2 and
parameter under hash-2 used.
All traffic (Learnt and Unlearnt): Source
and Destination MAC (Outer MACs
inside the payload, just after the MPLS
header), Ingress Port-Id.
MPLS – LSR All traffic: Source and Destination MAC
(Outer MACs of the Ethernet packet that
encapsulates MPLS packet)
All traffic: MPLS label stack (Two
labels deep), Source and Destination IP
(only when IP header immediately
follows MPLS header without any
Source and Destination MAC in between
inside the MPLS encapsulation), Ingress
Port-Id.
Table 12: LAG Hashing Fields used for 7210 SAS-T Network Mode (Continued)
Services and Traffic
direction (For exam-
ple -SAP to SDP)
Packet fields used for Hashing for dif-
ferent traffic types
With hash-1
Packet fields used for Hashing for dif-
ferent traffic types
With hash-2

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English