Copyright 1995 – 1999 Nokia. All right reserved. 3(10)
When you have all the files that you need on the PC, press disconnect on the 9000/i and exit the Nokia
Server software.
IMPORTING THE DATA TO THE NOKIA 9110 COMMUNICATOR
Follow the instructions below to move the data from the PC to the Nokia 9110 Communicator.
If you have already installed and used PC Suite for the Nokia 9110 Communicator, then skip the section
“Getting Started..”. If you use Win 3.11 or Mac, then see “Upgrading the Nokia 9110 Communicator
under Windows 3.11 / Mac”. See “Internet Access Point, Mailbox and Other Settings” at the end for
settings.
Getting started with Windows 95 / 98 / NT 4.0 or later
1. Install PC Suite on your PC from the CD-ROM supplied with the Nokia 9110 Communicator, and
choose a spare serial port on your PC.
2. Start PC Suite, and connect the 9110 to the spare serial port on your PC using the RS-232 Adapter
cable DLR-2 supplied with the 9110.
3. PC Suite will make a connection to the 9110. Accept the pop-up window that appears when you first
connect the 9110. If this does not happen then check the cable connection, and check that the serial
port is correct – Options, Preferences allows you to set the serial port.
4. Double-click the Import /Export icon on the left-hand side. PC Suite appears as shown in the
window below :
To Next Page
Loading...
