2 Connect the charger cable to the charger connector on the headset. The red
indicator light turns green when the battery is fully charged. Charging the battery
fully may take up to 2 hours.
3 Unplug the charger from the headset, then from the wall outlet.
The fully charged battery has power for up to 5 hours and 30 minutes of talk time or
up to 120 hours of standby time.
When the battery charge is low, you hear a voice prompt, the headset beeps every 5
minutes, and the red indicator light flashes. When the battery is charging, the red
indicator light is on.
Check the battery charge
Make sure the headset is switched on, then press
. A green light means there is a
sufficient charge level. If the light is yellow, you may need to recharge the battery
soon. If the light is red, recharge the battery.
Switch the headset on or off
Switch on
Press and hold
for 2 seconds. The headset beeps, and a green indicator light
flashes once.
The headset connects to the last connected phone or other device. If you have never
paired the headset, or you have cleared the pairings, the headset switches to pairing
mode.
Switch off
Press and hold
for 2 seconds. The headset beeps, and a red indicator light flashes
once.
If not connected to a phone within 30 minutes, the headset switches off.
Pair and connect the headset to your phone
Before using the headset, you must pair and connect it to a compatible device, such
as your phone.
1 Switch the headset off.
2Make sure your phone is switched on.
3 If you have never paired the headset, or you have cleared the pairings, switch the
headset on.
If you've earlier paired the headset with a device, press and hold
for 5 seconds.
4
To Next Page
Loading...
