Handle calls from two phones
If your headset is connected to two phones, you can handle calls from both at the same
time.
End an ongoing call, and answer a call on another phone
Press
.
Put an ongoing call on hold, and answer a call on another phone
Press and hold
for 2 seconds.
Switch between active and held calls
Press and hold
for 2 seconds.
End an ongoing call, and activate a held call
Press
.
If you redial or use voice dialling, the call is made on the phone you last had an active
call on with the headset.
Settings
Clear device pairings
1 To switch the headset off, press and hold
for 5 seconds.
2 Press and hold
for 9 seconds. The headset beeps twice, and the red and green
indicator lights alternate.
After the pairings are cleared, the headset enters pairing mode.
Product and safety information
Battery and charger information
This device has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the device as you
may damage the device.
This device is intended for use when supplied with power from the following chargers: AC–11, AC-3, AC-8, AC-15, DC-4, DC-9. The
exact charger model number may vary depending on the type of plug. The plug variant is identified by one of the following: E,
X, AR, U, A, C, K, or B.
The battery can be charged and discharged hundreds of times, but it will eventually wear out.
Talk and standby times are estimates only. Actual times are affected by, for example, device settings, features being used,
battery condition, and temperature.
If the battery has not been used for a long time, to begin charging, you may need to connect the charger, then disconnect and
reconnect it.
If the battery is completely discharged, it may take several minutes before the charging indicator is displayed.
7
To Next Page
Loading...
