ENGLISH
If voice prompts are activated, the
headset guides you with audible
notifications when you pair and
connect it.
To pair and connect the headset to a
device:
1. Make sure your mobile device is
switched on and the headset is off.
2. If the headset has not been
previously paired with a device,
switch on the headset. The headset
enters pairing mode, and the blue
indicator light starts to flash
quickly.
If the headset has been previously
paired with a device, to activate
pairing mode, make sure the
earpiece is placed in the storage
slot, and remove the earpiece from
the slot while you press and hold
the answer/end key for about 5
seconds. The blue indicator light
starts to flash quickly.
3. Within about 3 minutes, activate
Bluetooth on your device, and set it
to search for Bluetooth devices. For
details, see the user guide of your
mobile device.
4. Select the headset from the list of
found devices.
5. If necessary, enter the passcode
0000 to pair and connect the
headset to your device.
In some devices, you may need to
make the connection separately
after pairing.
When the headset is connected to at
least one device and is ready for use,
the blue indicator light flashes slowly.
To manually connect the headset to
the last used device, press and hold
the answer/end key for about 2
seconds (when no other device is
connected), or make the connection in
the Bluetooth menu of the device.
To Next Page
Loading...
