9
Copyright © 2009 Nokia. All rights reserved.
microphone, the headset beeps
twice.
To switch a call between the
headset and a compatible
connected device, press and hold
the answer/end key for about 2
seconds.
Allow connection to two
devices
You can have the headset connected
to two devices at the same time.
By default, the headset can only be
connected to one device at a time.
To allow the headset to connect to
two devices, switch off the headset,
and press and hold the power key,
and slide and hold the volume key
up for about 5 seconds. The blue
indicator light flashes twice.
To allow the headset to connect to
only one device, switch off the
headset, and press and hold the
power key, and slide and hold the
volume key down for about 5
seconds. The green indicator light
flashes twice.
If the headset can connect to two
devices at the same time and you
use redialling or voice dialling, the
call is made on the device that you
last used to make a call when the
headset was connected to it.
Clear settings or reset
To clear all the pairing settings from
the headset, switch off the headset,
and press and hold the power key
and the answer/end key at the same
time for about 5 seconds. The
headset beeps twice, and the red
and green indicator lights alternate.
After the settings are cleared, the
headset enters pairing mode.
To reset the headset if it stops
functioning, even though it is
charged, connect the headset to a
To Next Page
Loading...
Need help?
General
Weight and Dimensions
