9
432 Nokia Network Voyager for IPSO 4.0 Reference Guide
EBGP Load Balancing Example: Scenario #2
Configuring a Loopback Address on Platform A
1. Configure the interface as in “Ethernet Interfaces.”
2. Click Interfaces under Configuration > Interface Configuration in the tree view.
3. Click the Logical Address Loopback link.
4. Enter
1.2.3.4 in the New IP Address text box; then click Apply.
Configuring a Loopback Address on Platform B
1. Configure the interface as in “Ethernet Interfaces.”
2. Click Interfaces under Configuration > Interface Configuration in the tree view.
3. Click the Logical Address Loopback link.
4. Enter the
5.6.7.8 in the New IP Address text box; then click Apply.
Configuring OSPF on Platform A
1. Click OSPF under Configuration > Routing in the tree view.
2. Select the backbone area in the drop-down list for the interface whose IP address is
129.10.1.1; then click Apply.
3. Select the backbone area in the drop-down list for the interface whose IP address is
129.10.2.1; then click Apply
4. Enter
1.2.3.4 in the Add a new stub host column, then click Apply.
Configuring OSPF on Platform B
1. Click OSPF under Configuration > Routing in the tree view.
2. Select the backbone area in the drop-down list for the interface whose IP address is
129.10.1.2; then click Apply.
3. Select the backbone area in the drop-down list for the interface whose IP address is
129.10.2.2; then click Apply.
4. Enter
5.6.7.8 in the Add a New Stub Host column and then click Apply.
Configuring an EBGP Peer on Platform A
1. Configure an EBGP peer on Platform A as in “Ethernet Interfaces.”
2. Ente
r 1.2.3.4 as the local address on the main BGP configuration page.
3. Configure the inbound and route redistribution policies.
4. Click the link for specific peer you configured in Step 1. This action takes you the page that
lets you configure options for that peer.
To Next Page
Loading...
