Nokia Network Voyager for IPSO 4.0 Reference Guide 63
9. Click Incoming.
10. Select CHAP as the authentication method in the Authentication table.
11. Enter User in the Name text box under the From Remote Host section in the Authentication
table.
12. Enter Password in the Password text box under the From Remote Host section in the
Authentication table.
13. Click Apply.
14. Click the Incoming Numbers link.
15. Enter
384000 in the Number text box under the Add Incoming Call Information section.
16. Click Apply.
17. Click Save.
Sample Call Traces
Sample traces for call setup between the Nokia IP Security platform follow. The traces were
produced by issuing the following command on each device: “
tcpdump -i <interface>
.”
Traffic was generated by doing a “
ping 206.226.15.1
” on the Nokia IP330.
Note
To display the negotiated PPP values, run the tcpdump command with the -v switch.
To Next Page
Loading...