2
74 Nokia Network Voyager for IPSO 4.0 Reference Guide
The following figure shows the network configuration for this example.
1. Click Interfaces under Configuration > Interface Configuration in the tree view.
2. Select tok-s2p1 in the Physical column of the table.
3. Set the desired value in the Ring Speed column of the Physical configuration table.
Note
This setting must be the same for all hosts on the network to which the device connects.
4. Enter the desired MTU value.
5. In the Allow Source routes (Multi-Ring) field, select On or Off.
6. In the Select Use Broadcast instead of Multicast, select On or Off.
7. Under the Active column of the Logical interfaces table, select On or Off.
8. Click Apply.
Click Up to return to the interface configuration page.
9. Click the logical interface link to configure in the Logical column.
Nokia Platform A
Nokia Platform B
tok-s2p1c0 (192.168.3.2)
tok-s1p1c0 (192.168.3.1)
ser-s1p1c0 (192.168.2.1)
eth-s2p1c0 (192.168.4.1/24)
192.168.4.xxx
FDDI
192.168.1.xxx
(192.168.1.1/24)
192.168.3.4 192.168.3.5
fddi-s3p1c0
(192.168.2.93)
Provider
00038
Server
Server
Server
(Optional)
Server
(Optional)
Server
Token Ring
MAU
To Next Page
Loading...