GB 6
Installing the satellite dish
Ÿ Your satellite dish should be installed with a cable for you
to connect to the Mediamaster. If you do not have this cable
you will need to buy one from a dealer (tell the dealer you
need a coaxial cable and F-connectors).
Ÿ Connect the cable from the satellite dish to the socket
marked ”LNB IN” on the back of the Mediamaster.
If you need to fit the F-connectors onto the cable
Prepare each end of the cable as shown in the diagram.
You will need to fold back the outer braid (as shown).
Ÿ Slide the F-connector onto the cable, and then turn it
clockwise until it grips the braid.
Ÿ Ensure that 3 mm of the core is protruding from the end of
the connector.
There are many different types of TV/VCR and other
equipment that you can connect to the Mediamaster. In this
manual you will see some of the most common ways to
connect your equipment. If you use RF cables you will
have to tune your TV and VCR to the Mediamaster output
channel. If you have problems with your connections and
need help, contact your dealer or Service Provide.
Ÿ Connect the SCART cable between the main SCART
socket on the TV and the TV SCART socket on the
Mediamaster.
Ÿ Connect an RF cable from the TV/VCR output on the
Mediamaster to the RF input socket on the TV.
Ÿ Connect the TV aerial to the TV AERIAL input socket on the Mediamaster.
To Next Page
Loading...
