Nokia N9 RM-696 - Page 13

Nokia N9 (RM-696)
L1L2 Service Manual
13
Nokia I nternal Use only | Copyright © 2012 Nokia | All rights reserved
V ersion 8.0
7) Unscrew the two Torx+ size 4 screws. Do not
use them again. Discard them.
8) Insert the Unibody opening tool SS-282 to the
shown place and lever up the top left corner of
the WINDOW FRAME. Be careful not to damage the
PLASTIC BODY with the sharp edges of the SS-
282.
9) Insert the SS-282 to the shown place and lever
up the top right corner of the WINDOW FRAME. Be
careful not to damage the PLASTIC BODY with the
sharp edges of the SS-282.
10) Use the SRT-6 to open the left side of the
DISPLAY ASSEMBLY. Be careful not to damage the
PLASTIC BODY while releasing the DISPLAY
ASSEMBLY.
11) Use the SRT-6 to open the right side of the
DISPLAY ASSEMBLY.
12) Slightly pull the DISPLAY ASSEMBLY to
direction shown to release the three remaining
clips.
13) Turn the DISPLAY ASSEMBLY over. Be careful
not to damage the connectors underneath the
DISPLAY ASSEMBLY.
14) Disconnect the BATTERY with the tweezers to
avoid short circuit.