To monitor the usage of the SSD, open the Storage panel.
The panel displays information about the remaining capture time or capacity. To toggle between
these options, click on the indicator.
You will be alerted when running out of storage.
Temp e ratureTemp e rature
To monitor the temperature of the device, open the Temperature panel.
The panel displays information about the current temperature in °F or °C. To toggle between
these options, click on the indicator.
You will be alerted when reaching the overheating limits .
Audio GainAudio Gain
Audio monitoring gain can be used to change the loudness of the monitored spatial audio.
Please note that this setting does not affect the stored audio. Instead, audio is always stored
with full dynamic range.
Monitoring the SDI SignalMonitoring the SDI Signal
The tools located on the right area allow to monitor the SDI signal broadcasted by the OZO
Camera. The tools include alternative ways to view the signal, clipping indicators and preview
illuminant.
SDI SignalSDI Signal
The SDI signal is provided by the connected OZO Camera. If the SDI signal is not displayed by
OZO Remote, make sure the SDI cables are properly attached to the Camera, an SDI adapter has
been set up in your computer and the connected OZO Camera is in broadcasting mode.
Channel GridChannel Grid
The streams from the 8 lenses of the Camera are displayed in native equidistant fisheye
projection mode by default. This allows previewing all angles of the video streams.
The rectilinear mode is used when objects in the scene need to be monitored in their natural
appearance.
To switch to rectilinear mode, use the toggle buttons in the toolbar or the "Rectlinear View"
command in the "View" menu.
To Next Page
Loading...