Before you start make sure the device is
stable and mounted correctly.
1. Pull the latch (A) to it's full extension to
release the cartridge. Do not pull the cartridge
while doing so.
2. Pull the cartridge (B) out (and close the
latch).
3. To insert the cartridge pull the latch to it's
full extension.
4. Insert the cartridge with the groove
pointing downwards until you notice
resistance.
5. Release the cartridge and close the latch.
Charging BatteryCharging Battery
Insert a Digital Cartridge (A) into the Docking
Station (B).
Ensure a power cable is connected to the
Docking Station.
The LED on the Docking Station (C) should
flash white to indicate charging is in progress,
and show solid white to indicate when the
Digital Cartridge battery is fully charged.
Charging an empty battery can take up to 3
hrs.
A Digital Cartridge must be inserted at least
once to a powered Docking Station before it
can be used in the device.
A red light indicates a problem. Slow flashing
red indicates "No Battery found". Solid red
indicates "Cannot charge" (broken or
misplaced battery). Fast flashing red indicates
a malfunction.
To Next Page
Loading...