Nokia 5710 XpressAudio User Guide
3. Press the back cover down.
4. Slide up the earbud compartment cover.
Switch on the phone and connect the earbuds
1. To switch your phone on, press and hold the power key.
2. To switch on the earbuds, take them out from their compartment.
3. On your phone, select Menu > Earbuds > TWS connect , switch on TWS connect and
select Devices found > Nokia XpressAudio Earbuds .
CHARGE YOUR PHONE
Charge the battery and the earbuds
1. Plug the charger into a wall outlet.
2. To charge the earbuds with your phone, slide down the earbud compartment cover, and
place the earbuds in their slots. Slide up the cover.
3. Connect the charger to the phone. If the battery is completely discharged, it may take
several minutes before the charging indicator is shown on the phone screen. When the
earbuds are charging, the red indicator light on the earbuds is on and goes off once fully
charged.
4. When done, unplug the charger from the phone then from the wall outlet.
Tip: You can use USB charging when a wall outlet is not available. The efficiency of USB
charging power varies significantly and it may take a long time for charging to start and the
device to start functioning.
© 2022 HMD Global Oy. All rights reserved. 10
To Next Page
Loading...
Need help?
General
