1 Open the memory card slot cover (1, 2).
2 Make sure the contact area of the card is facing up. Push the card in, until it locks
into place (3).
3Close the cover.
Remove the memory card
Important: Do not remove the memory card when an application is using it.
Doing so may damage the memory card and the device and corrupt data stored on
the card.
You can remove or replace the memory card without switching the phone off.
1 Open the memory card slot cover.
2 Push the card in, until it is released, and pull the card out.
3Close the cover.
Charge the battery
Your battery has been partially charged at the factory, but you may need to recharge
it before you can switch on your phone for the first time. If the phone indicates a low
charge, do the following:
1 Connect the charger to a wall outlet.
2 Connect the charger to the phone.
3 When the phone indicates a full charge, disconnect the charger from the phone,
then from the wall outlet.
You do not need to charge the battery for a specific length of time, and you can use
the phone while it is charging.
Get started 9
To Next Page
Loading...
