23
To adjust the Recovery Speed, press the Power &
Settings button. Then use the right and left buttons to
select the Recovery Setting. The current value will be
displayed on the screen. Adjust it by using the plus (+)
and minus (-) buttons.
Tone Settings
These advanced tone settings offer 3 options to modify
the sounds The SIMPLEX ULTRA generates for targets.
Tone Break, Tone Frequency and Tone Volume.
Press the Power & Settings button once. Select the
tone setting using the right and left buttons.
When tone is selected, you can see all the tone settings
in the second row over the settings. Press the Ground
Balance / Confirm button to access the upper settings.
To go back to the lower settings, press the Pinpoint /
Back button.
15
NOTE: To go back to the main screen from tone settings,
press the Power & Settings button.
Tone Break
The Tone Break setting allows you to move the point
that separates the target zones.
The default Tone Break points may not provide you
with the distinction you need between the targets you
are looking for. With the Tone Break setting, you can
adjust the start/end points of target zones.
Tone Break setting only affects the mode currently
selected; changes made in one mode do not affect the
others.
Once you are in the upper tone settings, using the right
and left buttons, select the Tone Break setting. The
Tone Break point of the selected zone will be displayed
on screen. The selected zone will be displayed with a
closed frame.
15
You can change the Tone Break point using the plus (+)
and minus (-) buttons. To select the next zone, press the
Ground Balance / Confirm button.
Once you are done, you can go back to main settings
by pressing the Pinpoint / Back button once or back
to the main screen, by pressing the Power & Settings
button.
To Next Page
Loading...
Need help?
General
