24
Tone Frequency
This setting allows you to adjust the frequency of
target response tones as well as the Threshold tone
in the All Metal mode. Tone frequency ranges between
290 Hz (29) and 990 Hz (99).
Once you are in the upper tone settings, using the right
and left buttons, select the Tone Frequency setting. The
Tone Frequency of the selected zone will be displayed
on screen. The selected zone will be displayed with a
closed frame.
6029
You can change the Tone Frequency using the plus (+)
and minus (-) buttons. To select the next zone, press the
Ground Balance / Confirm button.
Once you are done, you can go back to main settings
by pressing the Pinpoint / Back button once or back
to the main screen, by pressing the Power & Settings
button.
Tone Volume
Especially in trashy sites, this setting will enable you
to detect conveniently by turning off or lowering the
volume of unwanted targets’ audio responses.
The Tone Volume can be adjusted for each target zone.
For example; in the Field mode, because there are two
zones, you can determine 2 different volume levels and
in 4-Tone mode, you can adjust the volume of each of
the 4 zones differently.
Tone Volume setting range is from 0 to 5. At 0, the
volume will be off. Tone Volume setting only affects the
mode currently selected; changes made in one mode do
not affect the others.
Once you are in the upper tone settings, using the
right and left buttons, select the Tone Volume setting.
The Tone Volume of the selected zone will be displayed
on screen. The selected zone will be displayed with a
closed frame.
55
You can change the Tone Volume using the plus (+) and
minus (-) buttons. To select the next zone, press the
Ground Balance / Confirm button.
Once you are done, you can go back to main settings
by pressing the Pinpoint / Back button once or back
to the main screen, by pressing the Power & Settings
button.
IMPORTANT! This feature will work on deeper targets
only! You will not be able to lower the volume of the
shallow targets. For these targets, you can turn the
volume off completely instead.
To Next Page
Loading...
Need help?
General
