Nolan N104 Absolute - Page 16

16 17
1.3 Place the Pinlock
®
inner visor on the visor. WARNING: The silicone-sealed prole
of the Pinlock
®
inner visor should be in contact with the inner surface of the visor.
1.4 Insert one side of the Pinlock
®
inner visor on one of the visor pins and hold it in
position (Fig. 5).
1.5 Widen the visor and fasten the other side of the Pinlock
®
inner visor to the second
pin (Fig. 6).
1.6 Release the visor.
1.7 Remove the protective lm from the Pinlock
®
inner visor and check that the entire
silicone-sealed prole of the inner visor adheres to the visor.
1.8 Fit the visor in the helmet.
CHECKING AND ADJUSTING THE INNER VISOR STRETCHING
Check the correct system assembly by opening and closing the visor. Check that
both visors are correctly fastened and do not move.
If the inner visor is not tightly xed to the visor, move the external adjustment levers
simultaneously upwards to increase the stretch (Fig. 7). This operation must be car-
ried out gradually. The maximum stretch is achieved when the pin adjustment exter-
nal levers are turned outwards.
WARNING!
The presence of dust between the two visors may produce scratches on both sur-
faces.
Scratched visors and inner visors may cause reduced visibility and must therefore
be replaced.
Regularly check the correct stretching of the inner visor to prevent the same from
moving and scratching both surfaces.
If the helmet visor fogs up and/or condensation forms between the visors, check both
for system correct assembly and stretching.
An excessive and early stretch of the inner visor may result in excessive adherence
against visor surface and/or permanent deformations with subsequent inability to
perform following adjustments correctly.
The extended use under special weather conditions may reduce system performance
and result in partial fogging and problems of condensation on the inner visor. In this
case, remove the inner visor from the helmet visor and dry it with dry and lukewarm
air to restore system efciency.
Intense sweating /breathing, the use under particular weather conditions (low tem-
peratures, and/or high humidity and/or sudden changes in temperature or heavy rain)
and intense and prolonged use may affect the performance of the system and cause
the fogging or formation of condensation on the inner visor.
In such cases, after using the helmet and to restore the system efciency, remove the
inner visor from the helmet visor and let it dry with dry and lukewarm air. The same
procedure must be applied to the helmet, in order to dry out humidity in case it has
formed up as a consequence of the conditions described above.
2 PINLOCK
®
INNER VISOR DISASSEMBLY
2.1 Remove the visor equipped with Pinlock
®
inner visor.
2.2 Widen the visor and release the Pinlock
®
inner visor from the pins (Fig. 6).
2.3 Release the visor.