Nolan N44 - VPS ASSEMBLY AND DISASSEMBLY; VPS System Management

19
- Always check that the VPS is properly positioned according to the
 different weather/environmental conditions and/or to the above mentioned
recommendations for use.
- We recommend using the VPS only and solely together with the approved
standard visor, which has a transmittance value greater than 80%.
- Since the VPSdoes notassureyouthe same protectionastheone provided
by the visor, it has to be used only when the helmet visor is pulled down.
- AlwaysmakesurethattheVPSiscleanandthatitisoperatingproperlyinorder
 toavoidscratchesand/oranomalouswearoniteverytimeitisactivated.
- ALWAYS check the correct VPS operation and in case of malfunctioning do
not use the helmet and contact immediately a Nolan authorized dealer.
- Pleaserefertothepropersectioninthehelmetuser’smanualfortheVPSand
visor maintenance and cleaning operations.
- The VPS anti-fog / anti-scratch treatment highly reduces fogging. Protracted
 periodsofadverseweatherand/orenvironmentalconditionsmightcause
 foggingand/orformationofcondensationontheVPS,whichentailsareduction
 ofvisibilityand/orsharpnessofvision:inthiscase,deactivatetheVPS.
- Incaseofrain,thedirectcontactofraindropswiththeanti-fog/antiscratch-
 treatedVPSquicklyreducessharpnessofvision,thuscausingscarcevisibility:
 inthiscase,deactivatetheVPS.
- ThespecialVPSanti-fogtreatmentisusuallysensitivetohightemperaturesor
heat sources. In this case, contaminations caused by contact with other
materials might occur. These contaminations will cause marks and stains to
develop. In these cases (e.g. when the helmet is kept in the top case on hot
days), it is recommended to make sure the visor is not touching other materials.
1. VPSDISASSEMBLY
The VPS has been designed to ensure an easy, quick and tool-free disassembly.
To remove the VPS system from the helmet, open the chin guard and lower the VPS by
pushing the side slider forwards (Fig. 11).
Hold the SX side part of the VPS and pull the VPS to front of the helmet (Fig. 13) in order
to release it from the side frame inside of the shell.
Repeat the same operation on the DX side of the helmet .
2. VPSASSEMBLY
To assemble the VPS system, open the helmet chin guard and make sure the side slider
is in forward position (Fig. 11).
Insert the VPS SX end into the left side frame inside the shell until you hear a click
providing the fastening of the VPS (Fig. 13).
Repeat the same operation on the DX side.
Make sure the VPS operates correctly by activating and deactivating it according to the
instructions above.
- If the visor and/or VPS opening/closing mechanisms are damaged or
malfunctioning, do not use the helmet and contact immediately a Nolan
authorized dealer.