20
X-552
INSTRUCTIONS FOR USE
2 CHECKING AND ADJUSTING THE STRETCH
Check that the PINLOCK
®
inner visor has been correctly assembled by opening and
closing the visor and ensuring that they do not move with respect to each other.
Should the PINLOCK
®
inner visor not be tightly xed to the visor, simultaneously move,
gradually and not excessively, both external adjustment levers turning them upwards,
to increase the stretch (Fig.7). The maximum stretch is achieved when the pin adjust-
ment external levers are placed outwards.
WARNING
- Dust between the two visors may cause both surfaces to scratch.
- Scratched PINLOCK
®
visors and inner visors may cause reduced visibility and
should therefore be replaced.
- Regularly check the correct stretch of the PINLOCK
®
inner visor to prevent it from
moving and scratching both surfaces.
- If, in use, the helmet visor fogs up and/or condensation forms between the visors,
check that the PINLOCK
®
inner visor is both properly assembled and stretched
- An excessive and early stretch of the PINLOCK
®
inner visor may result in exces-
sive adherence against the visor surface and/or permanent deformations with
subsequent inability to properly perform future adjustments.
- Intense sweating/breathing, use in particular weather conditions (low tempera-
tures, and/or high humidity and/or sudden changes in temperature and/or heavy
rain) and/or intense and prolonged use may affect the performance of the PIN-
LOCK
®
inner visor, causing fogging or condensation formation. In such cases, to
restore the system efciency after using the helmet, remove the PINLOCK
®
inner
visor from the helmet visor and leave it to dry in warm and dry air. The same pro-
cedure should be applied to the helmet, which should be left to dry to remove any
humidity that may have formed as a result of the conditions described above.
3 DISASSEMBLY
3.1 Disassemble the visor equipped with the PINLOCK
®
inner visor (see instructions
above).
3.2 Widen the visor and release the PINLOCK
®
inner visor from the pins (Fig.9).
3.3 Release the visor.
4 MAINTENANCE AND CLEANING
- Disassemble the PINLOCK
®
inner visor from the visor. Using a damp and soft
cloth, gently clean it with mild liquid soap. Remove all soap under running water.
- Leave the visor to dry in warm and dry air without wiping it.
- To preserve the visor’s condition over time, leave the helmet to dry in a ventilated
and dry place with the visor open after use. Keep it away from heat sources and
store it in a place away from direct light.
- Do not use solvents or chemical products.
VISION PROTECTION SYSTEM
(
VPS
) - (
VPS-16
)
The exclusive inner VISION PROTECTION SYSTEM (VPS) is a LEXAN™ (*) polycar-
bonate moulded sunscreen with scratch-resistant/fog-resistant treatment. It is very
simple and practical to use: just lower it to activate it or lift it to remove it from your eld
(*)
LEXAN is a trademark of SABIC.
To Next Page
Loading...
Need help?
General
