2 3
SVENSKASVENSKA
Power on/o
Press and hold the Multifunction button (1) for 2 seconds to turn the
headphones on. Press and hold the Multifunction button for 5 seconds to
turn the headphones o.
Pairing
Make sure the headphones are turned o. Press and hold the
Multifunction button ( 1) for 5 seconds to enter pairing mode. The
indicator (5) flashes red and blue. Open the Bluetooth settings on your
device and connect to "Nomadelic Solo 201". The indicator flashes blue
when the pairing is successful.
Pairing occurs automatically after this each time you start the
headphones.
Charging
The indicator (5) flashes red when the battery level is low. Connect the
USB-C cable to the charging port (6) and a computer or a USB power
adapter to charge the headphones. The indicator flashes red during
charging and turns o when fully charged.
Note! If the battery level is low, you can still use the headphones with a
3.5 mm cable. The headphones cannot be used during charging
Control music
Play/pause: Press the Multifunction button (1).
Next song: Press and hold the Volume + button (2).
Volume + : Press the Volume + button.
Previous song: Press and hold the Volume - button (3).
Volume - : Press the Volume - button.
ANC: Press ANC button (4) to turn noise reduction on or o.
Control calls and voice assistant
Answer and hang up a call: Press the Multifunction button (1).
Reject a call: Press and hold the Multifunction button for 3 seconds.
Voice assistant: press and hold the Multifunction button for 2 seconds.
Safety information
This product contains a rechargeable Li-ion battery and the battery
cannot be replaced. Maximum rotation of the headphone speaker joints
is 110° (90° right+20° left), do not twist further to avoid damaging your
headphones. To prevent possible hearing damage, do not listen at high
volume levels for long periods of time.
Specications
Bluetooth: 5.0
Frequency range: 20 Hz–20 kHz
Playback time, ANC on: 40 h
Playback time, ANC off: 60 h
Charging time: 2 h
Noise reduction: up to 20 dB
Wireless frequency: 2402–2480 MHz
Transmission power: 20 mW (Max.)
Use
Charge the headphones fully before rst use.
ENGLISHENGLISH
1
2
3
4
8
6
5
7
1 Multifunction button
2 Volume + /Next track
3 Volume - /Prevoius track
4 ANC button
5 Indicator
6 Charging port
7 3.5 mm port
8 Microphone
Overview
To Next Page
Loading...