with that record. Bar graph does not store a calibration graph with the event.
If a calibration graph is required, enable this option.
This feature is intended for use on instruments that are left in place for a
number of days at a time. You can use this feature to prove that the
instrument was operating each day but may not have been triggered during
the selected monitoring time period. The auto calibration record will occur at
midnight at the selected time period. In most cases, this selection should
remain at the default setting of NO AUTO CAL.
Use this option to see the status of any automatic dial-out activity from the
unit. It shows the last downloaded event, the last received event and the
last connection. It can also be used for all seismograph connections,
including computer and modem connections. Please keep in mind that if
the operator only viewed the last event at the time of connection to the
seismograph, this will show at this screen. The events before this may not
be downloaded.
To Next Page
Loading...