29
Use this option to set the baud rate of the instrument when some type of
modem is in use. The default value for this setting is 38400. Other options
are 115200, 57600, 19200 and 9600.
This is used for serial communication with the PC as well as modem
communication. This must be set to match the SuperGraphics program for
PC communication via serial or the modem for remote communication.
38400 is typical for modem use.
Use this option to check for the last factory calibration performed on the unit
by an authorized NOMIS facility.
Use this option to change the date and time. When you choose this option,
the cursor will start on the hour. All time is listed in military format, with hours
represented by numbers ranging from 1 to 23. After 23:59 (11:59 pm), the
numbers will change to 00 (midnight). Use the + and – keys to move
horizontally through the edit Process. Use the ↑ or ↓ keys to change the
settings at the cursor. The time will not begin to count until you press
ENTER.
To Next Page
Loading...