Introduction
7
Data values are bold and in square brackets: [ 60.0 % ]
Controllers, as the Ribbons and Pedals, are labelled in Bold Capitals: PEDAL 1
Programming steps to be performed are indented to the right and marked with a
triangle, like this: ▶
Notes on the previous programming step are even more indented to the right and
marked with a dubble slash: //
This will look e.g. like this:
Applying modulation to the PM self modulation of Oscillator A:
▶
Press PM A (Oscillator B) two times. Env A is highlighted in the display.
▶
Turn the Encoder to [ 30.0 % ].
ߊ Oscillator B is now being phase-modulated by the signal of Oscillator A.
The modulation depth is controlled by Envelope A at a value of 30.0%.
Every once in a while, you will find some notes of particular importance (at least we
believe so...).They are marked by an exclamation mark (which looks like this:
྇
Please note that there is …
Sometimes, you will find some explanations within a list of programming steps.
They provide a little more in-depth knowledge and are called “Excursions”.
They look like this:
߃
Excursion: Parameter Value Resolution
Some parameters need a ...
Here and there, you will find short recaps – they look like this:
5
Recap: Oscillator section
To Next Page
