nor-tec 57121 - Magnetic Lock; Introduction; Warnings; Use

7
GB
Introduction
To get the most out of your new product,
please read this instruction manual before
use. Please also save the instructions in case
you need to refer to them at a later date.
Warnings:
The function of the product may be impaired
if you do not follow the instructions for use.
Replace the product if it is damaged, worn or
defective.
Use
The product can be used on drawers and
cupboards with a front thickness of up to 25
mm.
Scan the QR code on the front of this manual
to see an installation guide for the product.
Please refer to the illustrations at the front of
these instructions.
1. Lock the product.
2. Assemble the product as illustrated.
3. Clean the installation point so that the
surface is free of grease, dust and dirt.
Remove the protective foil from the tape
and place the product in the desired
location so that the cupboard/drawer can
be closed. Avoid touching the adhesive
surface of the tape. Press and hold the
product in place for 30 seconds. The tape
achieves its maximum adhesion after 24
hours.
4. Remove the frame.
4B. The product can also be secured in place
using the supplied screws.
5. Unlock the product.
6. The product can be unlocked using the
supplied magnetic key.
7. Key storage.
MAGNETIC LOCK
Service centre
Note: Please quote the product model
number in connection with all inquiries.
The model number is shown on the front of
this manual and on the product rating plate.
For:
• Complaints
• Replacement parts
• Returns
• Guarantee issues
• www.schou.com
Manufactured in P.R.C.
Manufacturer:
Schou Company A/S
Nordager 31
DK-6000
Kolding
All rights reserved. The content of this manual may not
be reproduced, either in full or in part, in any way by
electronic or mechanical means, e.g. photocopying or
publication, translated or saved in an information storage
and retrieval system without written permission from
Schou Company A/S.