Need help?Do you have a question about the Noraxon Ultium EMG System and is the answer not in the manual?
General| System Type | Wireless EMG System |
|---|---|
| Channels | Up to 16 channels |
| Sampling Rate | Up to 4000 Hz |
| Resolution | 16-bit |
| Battery Life | Up to 8 hours |
| Input Impedance | > 100 MΩ |
| CMRR | > 100 dB |
| Noise | < 1 μV RMS |
| Bandwidth | 10-500 Hz |
| Data Transmission | Bluetooth |
| Wireless Range | Up to 30 meters |
Contra-indicated for individuals with implanted pacemakers.
Specifies required companion software: myoRESEARCH® (MR3.12+) and myoMUSCLE™.
Details components and functions of the Receiver's front and back panels.
Describes EMG Sensor front/top and back/bottom views, LEDs, buttons, contacts.
Step-by-step guide for connecting Receiver, Smart Leads, and Docking Station.
Instructions for installing and activating the myoResearch software.
Guide to setting system parameters like sample rate, RF network, and filters in MR3.
Details connecting and configuring Smart Leads, including firmware updates.
Repeats critical safety practices, including pacemaker and critical medical device warnings.
Proper sensor placement, securing to skin, and lead wire connection.
Steps to start a new measurement session within the myoMUSCLE module.
Methods for assessing signal quality using the Status Monitor and indicators.
Instructions for starting, stopping, saving, or discarding a measurement.
How the system captures and recovers data lost due to communication interruption.
Step-by-step guide for charging EMG sensors using the docking station.
Instructions on updating firmware of Ultium devices via MR3.
Lists common symptoms, reasons, and remedial actions for system issues.
To Next Page
