6. PROGRAM | 15
6
PROGRAM
The Program section contains functions such as loading and storing
programs, access to Live programs, keyboard split functionality and
more. This is also where menus containing System, Sound and MIDI
settings are found. The menus and their settings are covered in a
separate chapter, starting on page 22.
STORE
The STORE button is used for storing an edited program
to any location in the program banks. Storing a program
will overwrite the existing data in the selected memory
location.
M When the Nord Piano 5 is shipped from the factory its memory is
protected to avoid accidental overwriting of programs. To be able
to store Programs, the Memory Protect parameter needs to be set
to “Off” in the System menu. Read more about this on page 22.
STORING A PROGRAM
Here is how to store a program without changing its name:
1 Press the STORE button once. The Store LED will start blinking and
the display will show the name of the program and its location.
2 To select a different store location use the dial and/or the PROGRAM
SELECT 1-5 buttons. A program can also be stored to one of the
Live program locations by pressing the LIVE MODE button and then
selecting the desired Live location. The program at the selected
destination can be auditioned by playing the keyboard.
M To cancel an ongoing Store operation, press EXIT.
3 When a suitable location has been selected, press STORE again to
confirm the operation.
NAMING A PROGRAM (STORE AS...)
1 To store and name your program press STORE AS... (Shift + Store).
2 The ABC soft button brings up a row of alphanumeric characters.
Use the dial to set the character for the current position. Let go of
the ABC button to move the cursor ahead. The dial can be used to
move the cursor freely. The Ins soft button is used for inserting a
blank space at the cursor position and the Del soft button is used
for deleting the selected character.
3 To set a category for your program, hold down the Cat soft button
and select a category from the list.
4 Press STORE to bring up the Store Program To screen. Use the dial
and/or the Program Select buttons to select a location.
5 When a suitable location has been selected, press STORE again.
Naming programs can also be done with the Nord Sound Manager.
PROG VIEW
The PROG VIEW button switches between two distinct view modes for
the display. The default view shows only the Program name and number,
with the lower half of the display reserved for showing parameter hints
as panel controls are changed.
The second view mode shows the Program name and number in
smaller print and utilizes the lower half of the display to show the current
selection for each active Layer.
M The lower half of the display will show parameter hints as panel
controls are adjusted in this view mode too, temporarily hiding the
Piano and Sampßle Synth Layer information.
TRANSPOSE ON/SET
The Nord Piano 5 can be transposed in +6/-6 semitone steps on a
per-program basis. Pressing TRANSPOSE turns this function on or off.
Hold down TRANSPOSE and set the value by turning the dial. Transpose
settings are saved and recalled as part of a program.
STORE PROGRAM TO
A:12
Amber Upright
A
qrstuvwxyzABCDEFGHIJK
STORE PROGRAM AS
ABC DelCat Ins
mber Upright
A:11
White Grand
To Next Page
Loading...
