NORDIC FIRE SUPERIOR - Malfunctions and Solutions During Operation

Problem Solution
Backow of smoke into the room
when opening the stove door
the door may have opened too
abruptly, creating negative pressu-
re in the combustion chamber
slowly opening the door
closed, adjustable ue sha (if the
installation has such an option)
opening the sha
insucient air circulation in the
room where the stove is installed
Check the eciency of ventilation
and make sure there is enough air
in the room
atmospheric conditions
insucient dra
check the operation of the
installation chimney
Heating with low productivity or
phenomenon heater extinction
insucient wood in the stove
increase the amount of wood to the
required level
fuel humidity too high
use wood with a
humidity up to 20%
insucient dra check the eciency of ventilation
Low heating capacity with correct
combustion process in the stove
unsuitable, low-caloric wood was
used
switching to a more caloric type of
wood being burned
fuel humidity too high
use wood with a
humidity up to 20%
thin, ne pieces of wood are used
that burn quickly
use for smoking other thicker
clearance
Dirty glass, no self-burning glass
too slow combustion of wood
resulting in low combustion
chamber temperature
increase the amount of air in the
combustion chamber, use wood
with a moisture content of 20%
coniferous wood with high resin
content was used
changing wood type to dry
rewood
If the device does not work
correctly, it may be due to extreme
factors.
tall objects too close to the
chimney
increase the height of the
chimney or use a
'reman' or other type of hood
unsuitable atmospheric
conditions, e.g. wind or lack of
wind, low air pressure, high
humidity, fog, etc.
use a chimney pot, but if this does
not help, a chimney sweep should
be called in to determine the
source of the problem
MALFUNCTIONS AND SOLUTIONS DURING OPERATION
28