NordicTrack NTEL71318.6 - Page 11

11
143
143
7
8
24
25
14
16
16
16
40
40
44
44
13
119
138
8. See the inset drawing. Identify a Handlebar
Cover (40) and the Right Rear Leg Cover (44),
and slide them onto a Handlebar (16) as shown.
Insert the Handlebar (16) into the Right Pivot
Leg (13), and attach it with two M10 x 45mm
Bolts (119) and two M10 x 18mm Washers (138).
Press the Right Rear Leg Cover (44) into place.
Then, press the Handlebar Cover (40) into place.
Repeat this step on the other side of the
elliptical.
7. Identify the Left and Right Rear Belt Covers
(24, 25), and then attach them to the Left Pedal
Arm (14) with five M4 x 16mm Screws (143);
start all the Screws, and then tighten them.
Repeat this step on the other side of the
elliptical.