EasyManuals Logo

NordicTrack NTL29222.2 User Manual

NordicTrack NTL29222.2
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
33
SYMPTOM: The walking belt slows when walked on
a. Use only a surge suppressor that meets all of the
specications described on page 19.
b. If the walking belt is overtightened, treadmill per-
formance may decrease and the walking belt may
become damaged. Remove the key and UNPLUG
THE POWER CORD. Using the hex key, turn both
idler roller screws (C) counterclockwise, 1/4 of a
turn. When the walking belt is properly tightened,
you should be able to lift each edge of the walking
belt 2 to 3 in. (5 to 7 cm) off the walking platform.
Pinch near the foot rail (D) to expose and lift the
edge of the walking belt (see the inset drawing).
Make sure to tuck the edge of the walking belt back
under the foot rail after checking the tension. Be
careful to keep the walking belt centered. Then,
plug in the power cord, insert the key, and walk on
the treadmill for a few minutes. Repeat until the
walking belt is properly tightened.
c. Your treadmill features a walking belt coated with
high-performance lubricant. IMPORTANT: Never
apply silicone spray or other substances to
the walking belt or the walking platform unless
instructed to do so by an authorized service
representative. Such substances may deterio-
rate the walking belt and cause excessive wear.
If you suspect that the walking belt needs more
lubricant, see the front cover of this manual.
d. If the walking belt still slows when walked on, see
the front cover of this manual.
SYMPTOM: The walking belt is off-center or slips
when walked on
a. If the walking belt is off-center, rst remove the
key and UNPLUG THE POWER CORD. If the
walking belt has shifted to the left, use the hex
key to turn the left idler roller screw clockwise 1/2
of a turn; if the walking belt has shifted to the
right, turn the left idler roller screw counterclock-
wise 1/2 of a turn. Be careful not to overtighten
the walking belt. Then, plug in the power cord,
insert the key, and walk on the treadmill for a few
minutes. Repeat until the walking belt is centered.
The walking belt is centered when both edges are
covered by the foot rails (D).
C
D
D
2–3 in.
b
a
D
D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NordicTrack NTL29222.2 and is the answer not in the manual?

NordicTrack NTL29222.2 Specifications

General IconGeneral
BrandNordicTrack
ModelNTL29222.2
CategoryExercise Bike
LanguageEnglish

Related product manuals