34
b. If the walking belt slips when walked on, rst
remove the key and UNPLUG THE POWER
CORD. Using the hex key, turn both idler roller
screws clockwise, 1/4 of a turn. When the walking
belt is correctly tightened, you should be able to lift
each edge of the walking belt 2 to 3 in. (5 to 7 cm)
off the walking platform (see drawing b on page
33). Be careful to keep the walking belt centered.
Then, plug in the power cord, insert the key, and
walk on the treadmill for a few minutes. Repeat
until the walking belt is properly tightened.
SYMPTOM: The displays of the console do not
function properly
a. If the console does not boot up properly, or
if the console freezes and does not respond,
reset the console to the factory default settings.
IMPORTANT: Doing this will erase all of the
custom settings you have made to the console.
Resetting the console requires two people. First,
press the power switch into the off position. Next,
locate the small reset opening (E) on the top of
the console. Using a bent paper clip (F), press
and hold the reset button inside the opening, and
have a second person press the power switch into
the on (reset) position. Continue holding the reset
button (E) until the console turns on. When the
reset operation is complete, the console will turn off
and then turn back on. If it does not, use the power
switch to turn the treadmill off and then on again.
Once the console turns on, check for firmware
updates (see step 5 on page 29). Note: It may take
a few minutes for the console to be ready for use.
b
E
a
F
To Next Page
Loading...
Need help?
General
