Instruction Sheet 46-75
Page 14
2300 Retrofit
NOTE: This procedure must be followed be-
cause there are no stops or “clicks” when the
adjustment pot reaches the end of the
range. Turning the pot at least 15 turns in
any one direction assures that the end of
the range is reached.
NOTE: DO NOT touch the sensor cable in-
side the control unit. Touching the cable
may activate or deactivate the heated grid.
5. From this point, turn the pot until the red indicator LED goes
on and all indicator LEDs go off’.
NOTE: With the level control sensitivity
properly adjusted, the Melter Feeder fill se-
quence will begin and remain on until the
adhesive level is within 1 inch (2.54 cm) of
the sensor.
NOTE: If adhesive builds u.p on the sensor,
it may be necessary to increase the level
control sensitivity or to clean the sensor
lens.
Issued l/89
ONORDSON CORPORATION 198’3
All Rights Reserved
Pub. No. 108 428A
To Previous Page
Loading...