32
Installation
1. Apply Wall Packing to the rear side of the
remote controller.
2. Connect the remote controller wires to the
separate remote controller cord.
Phillips Roundhead
Wood Screw
Wall Anchor
3. Remove the cover of the remote control,
mark the location of the screw holes, and
drill holes for the wall anchors.
4. Insert the wall anchors, screw the remote
control to the wall and replace the cover.
Remote Controller Cord
Wall Packing
(take off the paper)
Remote
Control
Wires
Rear Side of
Remote Controller
To Next Page
Loading...
Need help?
General
