3
Controller to Client Conversion
Important: Please contact Nortek Security and Control technical support for assistance during this implementation. (800)-421-1587 or 760-438-7000
Note: All TE controllers and clients must be operating on the same software revision. System failure may occur if not updated to the same software revision. Refer to Nortek
Security and Control technical support for assistance in determining and/or updating the software revision.
1. Locate the panels MAC address.
Option 1: Locate on the control board and of the unit you are converting to a client. On the main PC board document the unit MAC address.
Option 2: Retrieve the MAC from the panel license page.
2. Log onto www.e3upgrade.com.
3. Click the License Now button.
4. Enter the last six (6) characters of the system
MAC address.
5. Click Next.
To Next Page
Loading...
Need help?
General
