EasyManua.ls Logo

North Star 49159 - User Manual

North Star 49159
25 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
SAVE THESE INSTRUCTIONS
5.5 HP Single-Direction Plate
Compactors
Owner’s Manual
Item 49159 Item 49161,
With Water Tank
WARNING: Read and understand all instructions, warnings, and cautions before
using this product. Failure to follow the instructions, warnings, and cautions may result in
serious personal injury and/or property damage.
Items # 49159 & 49161

Table of Contents

Questions and Answers

  • W
    William CharlesAug 11, 2025
    What to do if my North Star Power Tool engine is running but there is no vibration?
    • A
      April CampbellAug 11, 2025
      If your North Star Power Tool's engine runs but there's no vibration, several factors could be at play. First, ensure the engine throttle is fully opened and the accelerator lever is turned fully clockwise. Also, the V-belt or drive belt might be loose, worn, or broken, requiring adjustment or replacement. Finally, inspect the clutch for damage and replace if necessary.
  • M
    Mark LucasAug 21, 2025
    Why is my North Star Power Tool compactor not developing full speed?
    • C
      Cameron VillaAug 21, 2025
      If your North Star Power Tool compactor isn't reaching full speed, several issues could be the cause. Ensure the engine throttle is fully open and correctly adjusted. If the ground is too wet, allow it to dry before compacting. Check the drive belt for looseness or wear, adjusting or replacing it as needed, and ensure the engine mounting bolts are tightened. Inspect the vibrator housing oil level and condition, adding or changing the oil if necessary. Clean or replace a clogged air filter. If the engine speed is too low, use a tachometer to check and adjust/repair the engine to run at the correct speed.
  • S
    scottburkeAug 30, 2025
    What to do if North Star 49159 plate jumps or compacts unevenly?
    • C
      courtney44Aug 30, 2025
      If the North Star Power Tool plate jumps or compacts unevenly, it could be due to a ground surface that is too hard. Another potential cause is a loosened or damaged rubber isolator, which would need adjustment or replacement.

North Star 49159 Specifications

General IconGeneral
BrandNorth Star
Model49159
CategoryPower Tool
LanguageEnglish