STEP 1: Verify Package Contents
Verify package contents by emptying contents of
bag(s) and confirming all parts are included and
undamaged.
Tip: Do this at home before you
leave on your trip.
STEP 2: Install the Tent Poles
A) Select a smooth level site and spread out your
tent.
B) Extend poles and place in posi-
tion ready for installation. Take a
tent pole and push it through a set
of pole sleeves located at top of the
tent. Repeat process for remaining
tent pole. Poles will cross each
other at the center.
C) After sliding poles through
sleeves, gently flex poles into an
arch and insert ends onto pin-rings at tent base.
Caution: Make sure pole sleeve fabric is evenly
distributed along pole and does not catch at pole
joints. Undue stress could break pole or tear
fabric.
STEP 3: Attach the Rainfly
A) Slide bent rainfly pole through
sleeves located on underside edges
of rainfly.
B) Drape rainfly over tent (pole side
down). Insert tips of bent rainfly pole
into metal grommets located on pole
sleeves next to door.
C) Connect S-hooks on rainfly to pin-rings at tent
base.
STEP 4: Stake the Tent
A) Secure tent by driving stakes
through pin-rings at base of tent.
B) Secure corner of doormat by
driving stakes through webbing loops and one
stake through the grommet in the center of the
doormat.
ASSEMBLY INSTRUCTIONS
THIS RECREATIONAL PRODUCT REQUIRES TWO ADULTS TO ASSEMBLE.
* Unless otherwise specified all instructions will be given assuming the assembler is facing the front opening of the tent.
* Carefully fold out your poles, using caution to prevent snapping the shock-cording. Make sure each pole segment is “seated” into the next
section bef
ore flexing the pole during set-up.
DISASSEMBLY INSTRUCTIONS
* Make sure all windows and doors are unzipped to disassemble.
* Store all poles and stakes in their corresponding bags to prevent possible tearing or damage to fabric.
STEP 1: Remove the Stakes
Carefully remove stakes by pulling out the hook
ends. Tip: Do not pull or tug at the stake loops
sewn onto the fabric body. Remove excess soil
from the stakes and store them in their bag.
STEP 2: Remove Rainfly
A) Detach S-hooks that hold down rainfly.
B) Disengage rainfly pole from grommets. Fold
rainfly pole and store in pole bag.
C) Fold rainfly into a rectangular shape the width
of the pole bag.
STEP 3: Take Down Tent
Pull pole out of pin-ring assembly. Take pole out
of sleeve. Collapse poles and put in their bag.
STEP 4: Fold the Tent
Fold tent into rectangular shape the width of pole
bag. You can roll rainfly together with tent in one
step. Lay pole bag at one end of tent and roll
tightly together, slowly squeezing air out as you
go. Store tent in carry bag provided. (Following
these instructions will make it easier to fit tent
into bag.)
CAMPERS WANT TO KNOW
How do I get rid of mildew on my tent?
Mix
1
/
2
cup of LYSOL in 1 gallon of HOT
WATER. Sponge the tent and let dry. Then mix
1 cup of SALT and 1 cup of CONCENTRATED
LEMON JUICE in 1 gallon of HOT WATER.
Sponge the tent and let dry. Store tent in dry,
cool environment.
To Next Page
Loading...
