NorthStar SMARTCRAFT GATEWAY - 1 Introduction; Smartcraft Data Available from DIfferent Engines

4
SmartCraft gateways Installation and Operation Manual
NAVMAN
1 Introduction
The Navman SmartCraft
TM
gateway connects one
or two SmartCraft capable Mercury petrol/gasoline
engines to a SmartCraft capable Navman instru-
ment, such as the FISH 4380, FISH 4600 or TRACK-
FISH 6600. The single gateway is for single engines,
the dual gateway is for twin engines.
Adding the gateway extends the functions of the
Navman instrument, allowing the instrument to:
Display engine data, such as speed, RPM,
pressures, tank levels.
Control troll speed and display trim.
Sound an alarm if it detects an abnormal
engine condition.
This manual describes:
How to install a Navman SmartCraft gateway.
How to use the SmartCraft functions of a Nav-
man SmartCraft capable instrument. Refer to
the separate Navman instrument Installation
and Operation Manual for information on how
to install and use the instrument.
The engine data available in a system depends
on the type of engine used (see section 1-
1). The gateway replaces any fuel flow sen-
sors that might be plugged into the Navman
instrument .
It is vital to read this document and the associated
SmartCraft and Navman installation and operation
manuals before installing or using the system.
Steering Angle
Fuel level
Oil temperature
Oil Pressure
Engine Trim
Water Pressure
Engine temperature
Fuel Flow
Fuel Level
Engine voltage
Pitot water (boat) speed
RPM
4 Stroke 30 - 60
V-6 EFI Optimax 75- 115 Optimax 135-250 Optimax 225 DTS Verado Mercruiser 4.3 L Mercruiser 5.0 L Mercruiser 5.7 L Mercruiser 6.2 L Mercruiser 8.1 L 496 HO
Engine data available
1-1 SmartCraft data available from different engines
Engine type
The SmartCraft engine data available in a system depends on the type of engine. SmartCraft is a digital engine network
provided on some later model (2002 +) Mercury and Mariner Engines, both in-board and out-board.