Need help?Do you have a question about the Northwind 28 and is the answer not in the manual?
Lists necessary tools and materials for building the model.
Explains the R/C unit, transmitter, receiver, and servos.
Instructions for assembling the boat stand.
Steps for trimming deck openings using modeling knife and sandpaper.
Guide for installing rudder tube and keel parts.
Instructions for securing the radio box inside the hull.
Mounting of transmitter, receiver, and servos onto the servo tray.
Steps for attaching deck fittings like cleats and winches.
Guide for assembling mast sections and booms.
Instructions for preparing and attaching the main sail with battens.
Steps for preparing and attaching the jib sail with battens.
Fitting sails, shrouds, and stays to the mast.
Connecting jib sheets and main sheets to the sail servo.
Connecting the rudder and steering mechanism.
Guidance on setting sail angles and sheet tension.
Explains sailing principles and setup checks.
To Next Page
General