To Next PageTo Next Page
Need help?Do you have a question about the Norwood LumberMate MX34 and is the answer not in the manual?
Equipment is dangerous; follow all warnings, cautions, and instructions for safe operation.
Norwood disclaims liability; operators must meet health, age, and understanding criteria.
Attach swivel and fixed foot brackets to the fixture base using specific bolts and nuts.
Assemble revolving handle to crank handle and attach to cam shaft with carriage bolts.
Mount shingle cams onto the cam shaft and secure with set screws.
Attach wheel to roller cam mount and link arm to roller cam mount with bolts and nuts.
Mount the roller cam mount assembly to the opposite end of the cam shaft/handle assembly.
Insert bolt fixture and hinge tube into fixture base, securing with collars.
Align clamp saddle, secure with flanged bolts, and attach screw crank clamp.
Install 3/8" hex bolts and nuts as handle stops on the fixture base.
Notes on positioning handles, adjusting bolts for thickness, and securing jigs to the platform.
Steps for clamping the platform, setting taper, and producing lap-siding by rocking the jig.
Steps for clamping the platform, preparing cedar blocks, and cutting shingles with alternating cuts.
General