To Next Page
L
ldoyleAug 2, 2025
What to do if panel operation stops on Norwood LumberMax HD38 Industrial Equipment?
- EEric SwansonAug 2, 2025
If the panel operation stops, especially if a fuse blows during operation, take these steps: Ensure all fuses are checked and in good condition. Disconnect all the wires on the bottom of the panel. Reinstall the main power lead on the bottom of the panel. Plug the remote into the panel using the provided charge cord. Turn on the panel and listen for a double beep followed by a single beep. Finally, reinstall the accessory leads to the bottom of the panel and check for proper operation.
General