5. Instructions for use
1. The device is ready for use.
3. Select the correct suction power.
4. Hold your child in a stable position.
5. Insert the clean, dry nose tip into the child’s nostril.
2. Switch on the device by turning the control button.
6. Move the nose tip around gently to make sure that you get all
areas of the nostril.
low setting for newborns
medium setting for babies
high setting for small children and for
preschoolers
TIP: If the mucus is thin, you can use the device at a lower setting. If
it is thick, you can use the device at a higher setting than normal.
Sit your child onto your lap, hold them in your arms or sit them into
an upright position supporting their back with a pillow. You may
also sit them in an infant bouncer or infant seat.
In case of newborns, it is sufcient to hold the nose tip at the open
-
ing of the nostril. The connection point of the connecting tube
should point downwards while in use.
NOTE: In case of swollen nasal mucosa or blocked nasal openings,
use decongestant solutions or nasal sprays 30 minutes before
application.
For children under 6 months of age, you can use the nose tip de
-
signed for newborns. Above 6 months of age, it is recommended
to use the standard nose tip.
NOTE: Do not pinch or block the other
nostril while using the nasal aspirator.
NOTE: Any time you are not actively using the device, switch it off.
After the motor cycles off completely, you can restart it.t
The device should be connected to or
disconnected from the power network
only if the control button is in OFF position
(the device is switched off).
Do not aspirate water
with the device!
Do not use the nasal
aspirator for nasal washing!
Newborn’s nose tip Standard nose tip
To Next Page
Loading...
