ENGLISH
6
ASSEMBLY
1. With the Shaft Disc in place, insert the stem of the Cookie Press Shaft
into the center hole of the Motor Body. Push the Cookie Press Shaft
completely inside the Motor Body and press rmly into place.
2. Attach the Tube by aligning the pegs on the inside of the Tube with
the outside grooves of the Shaft Disc. The arrow on the Tube will
line up with the UNLOCK position on the Motor Body.
3. Grasp Tube rmly and turn until the top arrow on the Tube lines up with the
LOCK (
) position. You will hear a click when it is in the proper position.
4. Load freshly prepared cookie dough or lling into the unit with a spoon or spatula.
NOTE: Do not ll the tube past the MAX ll line.
To Next Page
Loading...
