5.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE/REMEDY
Power not turning on Check the plug; make sure it is properly
plugged into outlet.
Make sure lid and handle are locked and
handle is aligned properly
Mix is not dispensing Make sure the blending cage did not
loosen and float up.
Make sure the unit still has liquid inside
Make sure the spigot area did not freeze
Make sure unit is in the ON position.
CLEANING THE UNIT
1. Unplug the unit from the electrical outlet.
2. Dispense all remaining lliquid from the unit through the spigot.
3. Unlock top (See Illustration A) from base and rinse with clean water by pouring into
tank and dispensing thoroughly through the spigot until clear. Wipe inside and out
with a clean non-abrasive cloth or sponge. Dry with soft non-abrasive clean cloth.
4. Wipe the bottom base with a wet non-abrasive cloth and towel dry again using a
soft clean non-abrasive cloth to avoid scratching the surface.
Easily store your STAINLESS STEEL MARGARATOR™ for the next event!
By following these simple instructions, your STAINLESS STEEL MARGARATOR™ will be
fun for friends, family, and kids of all ages...by creating delicious servings of your favorite
beverages and making anytime an event.
NOTE: To prolong the life of your STAINLESS STEEL MARGARATOR™, be sure to
follow the cleaning instructions after every use and make sure the spout is flushed while
washing the unit to prevent build up. Never use anything abrasive on the base to maintain
the original finish and prevent scratches.
YOU MAY find a need to remove and clean the stainless grinding cage from the inside
base of the tank (trapped citrus pulp, etc.) Refer to the directions below to accomplish this.
6.
REMOVING AND SETTING THE STAINLESS GRINDING
CAGE
IT IS VERY IMPORTANT THAT THIS THE STAINLESS STEEL GRINDING CAGE IS
ASSEMBLED PROPERLY FOR YOUR UNIT TO WORK.
1. Inside the unit is a stainless steel grinding cage
and round plastic collar to lock the grinding cage into
place**.
2. Place the stainless steel grinding cage with the
smooth side (opposite of the 3 tab side) into the
plastic collar and twist until the notch of the stainless
steel grinding cage locks into the protrusion on the
plastic collar. (See illustration to the right).
3. Turn the assembled grinding cage (with plastic cover) over, so black plastic collar is
on the top to insert into the base of tank.
4. Looking down into the interior of the tank, you will see 2
Stainless Steel screws. This is where the clips attached to
the plastic collar lock the grinding mechanism down. (Fig. E,
Page 4)
5. When putting the collar into position, align the plastic collar
with the tabs with the indented postpositions. With firm but
gentle pressure, press the collar down until the tabs “click”
into place.
6. Once everything is in place, make sure the clips are pushed inward toward the
screws to lock the unit into position, (Fig. E, Page 4) and lift slightly to insure the
cage is in fact locked into position properly and will not release.
**THIS IS VERY IMPORTANT! IF THE COLLAR IS NOT LOCKED PROPERLY - THE
UNIT WILL GRIND BUT WILL NOT DISPENSE. Lock and unlock clips carefully, to
avoid breaking. Your STAINLESS STEEL MARGARATOR™ is now ready to fill with your
favorite liquid and use again.
IMPORTANT:
DO NOT SUBMERGE CLEAR TANK IN WATER!
To Next Page
Loading...
