Nostalgia Electrics HSB590 - PARTS & ASSEMBLY; Attaching and Removing the Grinding Cage

ENGLISH
5
PARTS & ASSEMBLY
Cord Location
The cord storage is located at the base of the unit:
Attaching and Removing the Grinding Cage
It is very important that the Grinding Cage is assembled properly in order for
the unit to work.
1. The Grinding Cage is attached to
the inside of the Blending Chamber
with a round Plastic Collar.
2. Place the Grinding Cage with the
smooth end (opposite of end
with three tabs) into the Plastic
Collar and twist until the notch of
the Grinding Cage locks into the
protrusion on the Plastic Collar.
3. Turn the assembled Grinding Cage with Plastic Collar over, so Plastic Collar
is on the top to insert into the base of Blending Chamber.
Screws
Grinder
Plastic Collar
Base
Blending Chamber
Lid
Spout
Grinding Cage
Clear
Window