ENGLISH
8
Control Panel
HOW TO OPERATE
CHOOSING A LOCATION
You will use the oven frequently, so plan its location for ease of use. Allow at least 2
inches on the sides, top and at the rear of the oven for air circulation. Do not place or
install the oven in any area where heat and steam are generated; for example, next
to or above a conventional gas or electric range or above a conventional wall oven.
Heat and steam may damage the electronics or the mechanical parts of the oven.
AFTER PLUGGING IN
As soon as the microwave is plugged into the outlet, the LED Display will ash three
times. Then the LED Display will ash ":", which prompts you to enter the time.
SETTING THE CLOCK
• While the LED Display reads ":", press the PRESET/CLOCK/DEFROST button for three
seconds. The LED Display will then read 0:00 and the 0: on the left will ash.
• Turn the PROGRAM DIAL to set the hour.
• Once you have set the hour, press the PRESET/CLOCK/DEFROST button
again and turn the PROGRAM DIAL to set the minutes.
• Once you have set the correct time, press the PRESET/CLOCK/DEFROST button
again or wait 5 seconds. When the numbers no longer ash, the time is set.
Micro Power
Pause/Cancel
Preset/Clock/Defrost
Express
Program Dial
To Next Page
Loading...
Need help?
General
